JabscoShop is closing. Last orders accepted 16th December 2024. Details...
D.C. Flexible Impeller Pumps
For a really dry bilge JABSCO flexible impeller pumps self-prime rapidly from dry, can handle moderate amounts of suspended solid matter, and will maintain their flow rate against discharge heads of several metres. While they are not as quiet as submersibles, taking more current for less flow at low heads, they are robust, fully serviceable, and, unlike submersibles, able to pump the bilge dry almost to the last drop.Recent Jabsco impeller pump models have built-in dry running protection (pictured above). For details key 'Utility' in the search box on the right of this page.Even without built-in protection in the pump itself, extended protection against dry-running damage to the impeller can be secured by attention to the configuration of the discharge pipe from the pump. For technical assistance contact us with details of your proposed installation.
- No Jabsco pump should be used for petrol, solvents or any liquid with a flash point below 37oC( 98oF)
Showing 1 - 14 of 14
 

Connections for 25mm (1”) bore hose or use ½” hose adapters

Connections for 25mm (1”) bore hose, ½” NPT internal thread
Adds approx. 125 lbs. (56kgs) of ballast water per minute
 
 

Ports ½” BSP threaded (use ¾” hose adapters), plus connections for 25mm (1”) bore hose

Ports ½” BSP threaded (use ¾” hose adapters), plus connections for 25mm (1”) bore hose
 
 

Connections for 19mm (¾”) bore hose or use 3/8” hose adapters

Connections for 19mm (¾”) bore hose or use 3/8” hose adapters
 
 

Connections for 25mm (1”) bore hose or use ½” hose adapters

Connections for 25mm (1”) bore hose or use ½” hose adapters
 
 
 
 
 
 

24volt dc 0.25kw IP54 Electric Motor, Nitrile oil-resistant impeller.
 
Showing 1 - 14 of 14